Similar to the first module this one is based on a solid 5mm MDF board. Following my initial plans (see Part 1) it measures 45cm x 72cm.
 |
| The concept for the port modules with two dock sections encapsulating a water board |
"Have no fear of perfection, you’ll never reach it."
Salvador Dali
"If you hear a voice within you say, 'You cannot paint', then by all means paint, and that voice will be silenced."
Vincent Van Gogh
Monday, September 22, 2014
The Port of Gierburg - Part 4: Dock Section II Ground Level WIP
After completing the first section of my Port of Gierburg gaming table it is time to start with the second module. This one will be a lot more difficult and a lot more exciting. Due to its complexity I will handle the (under)ground level first and then tend to the rest later.
Similar to the first module this one is based on a solid 5mm MDF board. Following my initial plans (see Part 1) it measures 45cm x 72cm.
Similar to the first module this one is based on a solid 5mm MDF board. Following my initial plans (see Part 1) it measures 45cm x 72cm.
Subscribe to:
Posts (Atom)
